Across Florida · Vetted local pros
Get matched with a automatic gates pro in Sunrise, FL
Automatic Gate Repair for homes in Sunrise and the surrounding area, by a vetted MB pro near you. Free estimate.
What to check first
What you might be seeing
- Gate stops partway, or opens but won't close
- Remote or keypad does nothing, or only works up close
- Motor hums or grinds but the gate barely moves
- Gate stopped working after a thunderstorm or power flicker
- Gate sags, drags or scrapes as it travels
Safe to check yourself
- Look at the photo-eyes on each side of the gate. Check that nothing blocks them, such as a leaning plant, a bin or a spiderweb.
- Try a fresh battery in the remote and test the keypad or wall button, to tell a transmitter problem from an operator problem.
- Look at the operator's status light, and listen for a click, hum or nothing at all when you press the button. Note what you see and hear for your pro.
- With the gate stopped, look along the track or swing path for debris, standing water or rust. Do not reach into the path.
Stop and get a pro if…
- The gate does not reverse when it meets an obstacle, or closes hard on something. Stop using it, because working photo-eyes and entrapment protection matter.
- You smell burning, see scorch marks, or find exposed wiring or a wet control box after a storm. Keep clear of line-voltage work.
- A hinge post, column or footing is leaning or cracked, or the gate has come off its track or hinges.
- The gate is stuck open or closed and you would have to force it by hand or work on the operator.
What to ask the pro
- Does the repair involve line-voltage electrical work, and who is the licensed electrical contractor doing it?
- Will the work need a permit, and who pulls it?
- Does the operator meet UL 325 entrapment-protection requirements, and are photo-eyes part of the quote?
- If a new gate, column or footing is involved, how does the design meet Broward wind-load rules and any product approval?
- Can I get the scope in writing with the free estimate before work starts?
Sunrise was mostly built out between the late 1960s and the 1990s, and the Census puts the median home here at about 1982. That means many driveway gates, community entry gates and operators are decades old and now fighting humidity, daily summer thunderstorms and rust. If your gate stalls halfway, ignores the remote, grinds, or won't close after a storm, age and moisture are the usual suspects.
Call (954) 707-6550 or send the form, and we match you with a vetted, independent, locally owned pro near you and book the visit. We stay your point of contact. Your MB pro gives the free estimate and can help with opener repair or replacement, swing and slide gate hardware, keypads and intercoms, safety sensors and battery backup.
Sunrise's western edge backs onto the Everglades water conservation areas, so many properties deal with a high water table, heavy summer rain and strong sun. Sun fades and warps gate components on west- and south-facing sides, and humid air promotes rust on hinges, rollers and lock cylinders. Sunrise is about 10 miles inland, so direct salt spray is limited. Much of the housing stock is now 30 to 55 years old, so many original openers and community entry gates predate current Miami-Dade/Broward wind-load codes.
Problems to watch for in Sunrise
Lightning and surge damage
Summer storms in Sunrise can send surges through the power line and damage an operator's control board. A gate that died right after a storm often points here.
Blocked or misaligned photo-eyes
Safety sensors that are dirty, knocked out of line or failed can stop a gate from closing. They are a key entrapment safeguard, so they should be working, not bypassed.
Rusted hinges, rollers and tracks
Year-round humidity and heavy rain corrode moving parts, which makes the motor work harder and shortens its life.
Sagging or warped gate leaves
Sun exposure on west- and south-facing elevations can warp panels and loosen hardware until the gate drags or no longer latches.
Dead remotes, keypads and intercoms
Moisture in keypads and weak batteries or receivers are common causes of a gate that seems to ignore you.
Power-outage lockouts
After hurricane-season outages, a gate with no battery backup can be stuck shut or open. Backup power and a manual release are worth asking about.
What your MB pro can help with
- Opener diagnosis and repairYour MB pro checks the operator, control board and wiring, and gives a free estimate to repair or replace it.
- Swing and slide gate hardwareHinges, rollers, tracks and latches worn by Sunrise humidity can be serviced or swapped by your pro.
- Safety sensors and loopsPhoto-eyes and vehicle loops can be aligned, repaired or replaced so the gate reverses as it should.
- Keypads, intercoms and backup powerYour pro can set up access devices and battery or solar backup, useful when storms knock out power.
- New gate installationFor a new gate or operator, your pro handles the design and the permit questions that come with it.
Permits and codes in Sunrise
Florida does not issue a dedicated statewide automatic gate license, and mechanical gate and operator service is often done without a construction license. The line-voltage electrical work feeding an operator must be done by a licensed electrical contractor under the DBPR Electrical Contractors' Licensing Board, and new gate structures, columns or footings may require a licensed contractor. Verify scope and licenses on the Florida DBPR website. A new gate, operator, columns or footings and their electrical circuit generally need building and/or electrical permits, while like-for-like repair of an existing operator usually does not. Sunrise is in Broward County, part of the High-Velocity Hurricane Zone, so gate structures face stricter wind-load provisions and exterior products there may need a Miami-Dade Notice of Acceptance. Operators are expected to meet UL 325 and ASTM F2200, and the fire marshal may require emergency access such as a Knox box or key switch. Confirm locally with the building department.
Your MB pro handles the permit when the job needs one. You can look up a contractor's license at Florida DBPR.
When to reach out
Demand rises ahead of and during hurricane season, June through November and peaking August to October, and again in the dry winter months when seasonal residents return and deferred repairs get scheduled. If your gate is acting up, booking before a storm is easier than after one. Call (954) 707-6550 or request a free estimate with the form on the page, and we will match you with a vetted pro near you and book the visit.
We match homeowners with pros near Sunrise Golf Village, Welleby, Springtree, Sunrise Lakes, New River Estates, the Sawgrass Mills area, the Sunrise Civic Center / City Hall area, and the Flamingo Road, Nob Hill Road and Sunset Strip corridors.
How it works
Step 1
Tell us what you need
Call or send the short form with your city and the job. Estimates are free.
Step 2
We match you with a vetted pro near you
We pick a vetted pro from our network who works in your part of Florida and book the visit.
Step 3
Your pro gives a free estimate and does the work
Your MB pro looks at the job and gives you a free estimate. You decide whether to go ahead — and we stay your point of contact.
Automatic Gates in Sunrise: common questions
- Why did my Sunrise gate stop working after a thunderstorm?
- Summer storms bring lightning and power surges that can damage an operator's control board, and heavy rain can get into keypads and control boxes. Don't open the box yourself. Note the status light and any sounds, then request a free estimate.
- Is it safe to bypass the photo-eyes so my gate will close?
- No. Photo-eyes are part of the entrapment protection operators are expected to have under UL 325. Check that nothing is blocking them, and if the gate still won't close, have a pro repair the sensors.
- Do I need a permit for gate repair in Sunrise?
- Like-for-like repair of an existing operator usually does not need one, but a new gate, operator, columns, footings or a new electrical circuit generally does. Your pro should confirm with the local building department and handle any permit.
- My community has an entry gate. Who do I call?
- Many Sunrise communities are governed by an HOA or condo association, so check first who owns and maintains the shared gate. For a private driveway gate, call us and we will match you with a pro near you.
- Do I need a licensed electrician for my gate operator?
- Florida requires the line-voltage electrical work feeding an operator to be done by a licensed electrical contractor. Mechanical gate service often needs no construction license. You can verify any license on the Florida DBPR website.
Request a free automatic gates estimate in Sunrise
Tell us what's going on. We'll match you with a vetted pro near you.
- 1Tell us what you need.
- 2We match you with a vetted pro near you.
- 3Your pro gives a free estimate and does the work.
Prefer to talk?
(954) 707-6550