Across Florida · Vetted local pros
Local automatic gates pros, matched for you in West Palm Beach, FL
Automatic Gate Repair for homes in West Palm Beach and the surrounding area, by a vetted MB pro near you. Free estimate.
What to check first
What you might be seeing
- The gate opens slowly, stalls halfway or stops and reverses on its own
- The motor hums or clicks but the gate does not move
- The keypad, intercom or remote went dead after a thunderstorm or power outage
- Visible rust or stiffness in hinges, rollers or the latch, especially close to the water
Safe to check yourself
- Try the remote and the wall keypad. If one works and the other does not, the problem is likely the remote or keypad, not the motor.
- With a flashlight, look along the track or swing arc for debris, mulch, a shifted object or a bent section. Look only; do not reach in.
- Look at the photo-eye lenses on each side of the opening for dirt, webs or a knocked-out alignment, and note any blinking lights.
- After a storm, check whether the operator shows any indicator light and whether neighbors also lost power. Note rust on hardware and tell the pro.
Stop and get a pro if…
- The gate does not stop or reverse when it meets an obstruction. That points to failed entrapment protection, so keep people and pets clear.
- You see exposed wires, a burning smell, water inside the operator box or a breaker that keeps tripping. The electrical work needs a pro.
- A post is leaning, a column or footing is cracked, or the gate is bent or sagging. Those are structural problems.
- A spring, chain or arm under tension looks broken or loose. Do not adjust it yourself.
What to ask the pro
- Is a permit needed for this job? A like-for-like operator repair usually does not need one, but new gates, columns or electrical circuits generally do.
- Who handles any line-voltage electrical work? In Florida it must be done by a licensed electrical contractor, which you can verify on the DBPR website.
- Will the repair keep or restore UL 325 entrapment protection, such as working photo-eyes?
- Does my HOA or the fire marshal require emergency access such as a Knox box or key switch, and does stainless or galvanized hardware make sense near the salt air?
- Can I have the scope and the free estimate in writing before work starts?
In West Palm Beach, gates along Flagler Drive and near the Intracoastal sit in salt-laden air that corrodes motors, hinges, keypads and lock hardware much faster than inland. The Census puts the median home here at 1987 construction, so many gates and operators are decades old. About half of homes are owner-occupied, so a repair often involves an HOA or landlord as well. Plan around salt corrosion, the June 1–November 30 hurricane season, and the entrapment sensors the job must keep working.
Call (954) 707-6550 or send the form, and we match you with a vetted, independent pro near you in West Palm Beach and book the visit. We stay your point of contact. Your MB pro gives the free estimate, then handles opener repair or replacement, swing and slide gate hardware, keypads, intercoms, safety sensors and battery or solar backup.
Salt-air corrosion is the main maintenance issue in West Palm Beach. Homes on the barrier-island side, along Flagler Drive and near the Intracoastal go through gate motors, rollers and deadbolts faster than inland properties, and stainless or galvanized hardware is often worth the upgrade. The historic districts near downtown add 1920s-era structures with non-standard openings and original hardware. Gated communities west of I-95 were built far more recently. Summer lightning and power surges can also damage operators and control boards, so the wet season matters here too.
Problems to watch for in West Palm Beach
Corroded motors and hardware
Salt-laden air near the Intracoastal and Flagler Drive rusts operator housings, hinges, rollers and latches, which leads to slow, noisy or stuck gates.
Storm and surge damage
Lightning and power surges during the June–September storm season are a major cause of operator and control board failures across Florida.
Failed safety sensors
Photo-eyes and loops that are dirty, misaligned or corroded can leave a gate without working entrapment protection.
Dead keypads and intercoms
High humidity and heavy summer rain get into keypad and intercom enclosures and cause intermittent or total failure.
Outage and backup trouble
After a hurricane or outage, a gate may be stuck shut or open, and battery or solar backup can be worn out or missing.
Older, non-standard openings
In the historic districts near downtown, original 1920s-era hardware and undersized openings can make a standard replacement operator a poor fit.
What your MB pro can help with
- Opener repair or replacementYour MB pro diagnoses the operator and tells you whether a repair makes sense or the unit has reached the end of its life in this salt air.
- Swing and slide gate hardwareHinges, rollers, tracks and latches can be repaired or swapped for corrosion-resistant options suited to the coast.
- Keypads and intercomsYour pro can restore or replace entry controls that failed after a storm or from moisture.
- Safety sensors and loopsPhoto-eyes and loops can be aligned, repaired or replaced so the gate meets entrapment-protection expectations.
- Battery or solar backupYour pro can add or service backup power so the gate still works during a hurricane-season outage.
Permits and codes in West Palm Beach
Florida does not issue a dedicated statewide automatic gate license, and mechanical gate and operator service is often done without a construction license. The line-voltage electrical work feeding an operator must be done by a licensed electrical contractor under the DBPR Electrical Contractors' Licensing Board, and new gate structures, columns or footings may require a licensed contractor. Verify the scope and any license on the Florida DBPR website and with the local building department. A new gate, operator, columns, footings or electrical circuit generally needs a building and/or electrical permit, while a like-for-like operator repair usually does not. Gates on or near a public right-of-way may need extra approval. Operators are expected to meet UL 325 and ASTM F2200 standards, gate structures must meet Florida Building Code wind-load requirements for this area, and the local fire marshal commonly requires emergency access, so confirm locally. Your MB pro is responsible for any permit and any license the work requires.
Your MB pro handles the permit when the job needs one. You can look up a contractor's license at Florida DBPR.
When to reach out
Demand rises in late spring and early summer as owners prepare for hurricane season, again after any named storm, and in October–November when snowbirds reopen seasonal homes and condos. If your gate is acting up, getting it looked at before the season peaks beats waiting for a storm. Call (954) 707-6550 or request a free estimate with the form on the page. MB Home Improvements has offices in Tamarac and Plantation, and one number covers every home service.
We match homeowners with pros in Downtown / Clematis Street, Rosemary Square, Northwood, Northwood Shores, El Cid, Flamingo Park, Grandview Heights, Prospect Park, SoSo, Pleasant City, Ibis Golf & Country Club and Bear Lakes.
How it works
Step 1
Tell us what you need
Call or send the short form with your city and the job. Estimates are free.
Step 2
We match you with a vetted pro near you
We pick a vetted pro from our network who works in your part of Florida and book the visit.
Step 3
Your pro gives a free estimate and does the work
Your MB pro looks at the job and gives you a free estimate. You decide whether to go ahead — and we stay your point of contact.
Automatic Gates in West Palm Beach: common questions
- Does salt air really shorten the life of a gate operator in West Palm Beach?
- Yes. Homes near the Intracoastal and along Flagler Drive go through gate motors, rollers and deadbolts faster than inland properties. Your pro can suggest stainless or galvanized hardware, and regular rinsing and service help.
- Do I need a permit to repair my gate opener?
- A like-for-like repair of an existing operator usually does not need one. A new gate, operator, columns, footings or a new electrical circuit generally does. Your MB pro handles any permit, and you can verify with the local building department.
- Who can do the electrical work on my gate?
- The line-voltage electrical work feeding an operator must be done by a licensed electrical contractor in Florida. Verify any license on the DBPR website, and ask your pro who will handle that part.
- My gate keypad died after a summer storm. What should I check first?
- Test the remote, then look for debris or obvious damage and see whether the operator shows any indicator light. Lightning and surges in the storm season often damage controls, so call a pro rather than opening the operator box yourself.
- Will my HOA need to approve gate work?
- Possibly. Many West Palm Beach homes sit in HOA-governed or gated communities, and exterior work can need association approval in addition to any permit. Check with your association before work starts.
Request a free automatic gates estimate in West Palm Beach
Tell us what's going on. We'll match you with a vetted pro near you.
- 1Tell us what you need.
- 2We match you with a vetted pro near you.
- 3Your pro gives a free estimate and does the work.
Prefer to talk?
(954) 707-6550