MB Home Improvements

Across Florida · Vetted local pros

Find the right chimneys pro in Coral Springs, FL

Chimney Cleaning & Repair for homes in Coral Springs and the surrounding area, by a vetted MB pro near you. Free estimate.

What to check first

What you might be seeing

  • A musty or smoky smell near the fireplace, especially after a summer downpour
  • Water stains on the ceiling or wall around the chimney
  • Cracked stucco, a crumbling crown or rust streaks on the stack
  • Scratching or chirping sounds from the flue, or debris in the firebox
  • Heavy black soot or flaky buildup inside the firebox

Safe to check yourself

  • From the ground, look at the stack and top with a flashlight or binoculars for cracks, a missing cap or loose stucco. Do not climb up.
  • With the fireplace cold, shine a flashlight into the firebox and check for soot, debris, damp spots or nesting material.
  • Open and close the damper handle to see if it moves freely and seals. Never do this with a fire lit.
  • Look at the ceiling and walls around the chimney after heavy rain for new stains, and press the test button on your carbon monoxide alarm.

Stop and get a pro if…

  • Stop using the fireplace if you see thick, shiny or tar-like creosote, or if smoke comes back into the room.
  • If a carbon monoxide alarm sounds, get everyone outside and call emergency services first.
  • Any gas log or gas appliance venting problem needs a licensed pro, not a DIY fix.
  • A leaning, cracked or storm-damaged stack, or anything that means getting on the roof, is a job for a pro.

What to ask the pro

  • Do you hold CSIA certification for sweeping and inspection?
  • If the job is a rebuild, liner or gas work, which Florida license do you hold? I will check it on the DBPR website.
  • Will the work need a permit from the City of Coral Springs or Broward County, and who pulls it?
  • Do the caps and flashing you plan to use meet Broward's High-Velocity Hurricane Zone wind requirements, including a Miami-Dade NOA where required?
  • Can I have the estimate in writing, with the scope listed?

Homes in Coral Springs have a median build year of 1986, according to the Census, and wood-burning fireplaces and chimneys are rare in this city's block-and-stucco housing. The chimneys that do exist have often gone years without a close look. Hire a pro who works on chimneys and masonry, not a generalist. Florida does not license chimney sweeps at the state level, so ask about voluntary CSIA certification. Any structural rebuild or gas venting work does require a properly licensed contractor.

Call (954) 707-6550 or send the form, and we match you with a vetted, independent pro near you and book the visit. We stay your point of contact. Your MB pro gives the free estimate and can help with sweeping, inspections, caps, crowns, flashing, waterproofing and stucco repair. Most homes in Coral Springs are owner-occupied, so you decide on the repairs, though your HOA may want to review exterior changes.

Coral Springs sits in Broward County's High-Velocity Hurricane Zone, so a chimney cap, crown or flashing has to be attached to resist high wind uplift and wind-driven rain. The May-October wet season and the city's humid air keep stucco and masonry damp, which can lead to cracks and leaks. Because the city is a planned community with many HOAs, exterior finish changes may need architectural-review approval. Ask your pro to help you find out whether you need it before work begins.

Problems to watch for in Coral Springs

Cracked crowns

Heavy summer rain can enter through a cracked crown, and in a city this storm-heavy that water can soak the masonry below.

Failed flashing

Where the chimney meets a barrel-tile or shingle roof, worn flashing can let wind-driven rain into the attic.

Missing or loose caps

With no cap, rain and animals can get into the flue. In the HVHZ, a replacement cap has to resist high wind.

Creosote buildup

A fireplace used only a few times a year can still build up creosote, and a chimney fire is a real hazard.

Stucco and masonry damage

Many Coral Springs homes are now 30 to 50 years old, so stucco on the chimney chase can crack or let in moisture.

Storm damage to the stack

After a tropical system, a chimney stack can be loosened or cracked and should be checked before the next use.

What your MB pro can help with

  • Sweeping and inspectionYour MB pro will sweep the flue and inspect it for creosote, blockages and damage. You get a clear picture of what the chimney needs.
  • Caps and dampersYour MB pro can fit a cap to keep out rain and animals, and repair or replace a damper that no longer seals.
  • Crown and flashing repairYour MB pro will repair cracked crowns and failed flashing, which is where wind-driven rain most often gets in.
  • WaterproofingYour MB pro can waterproof the chimney masonry against the heavy rain of the Coral Springs wet season.
  • Masonry and stucco repairYour MB pro can repair cracked stucco and masonry on the stack, and work with you on any HOA requirements.

Permits and codes in Coral Springs

Florida does not license chimney sweeps at the state level, so cleaning and inspection are generally unlicensed work. Many reputable sweeps hold voluntary CSIA certification instead. Structural masonry rebuilds, fireplace alterations, and gas appliance or venting work do require an appropriately licensed contractor, so verify the correct license category on the Florida DBPR website. Sweeping and inspection need no permit. A rebuild, relining, or a fireplace or gas appliance installation typically needs a permit from the local building department, which the pro handles. Chimney construction falls under the Florida Building Code, and because Coral Springs is in the HVHZ, exterior products such as caps generally need a Miami-Dade NOA. Confirm the details with the local building department.

Your MB pro handles the permit when the job needs one. You can look up a contractor's license at Florida DBPR.

When to reach out

Demand rises ahead of and during hurricane season, roughly May through November, and again in the dry winter months when seasonal residents return and schedule deferred maintenance. A cracked crown or failed flashing is worth fixing before the summer storms. Statewide, off-season chimney work is often water intrusion repair after summer storms. Call (954) 707-6550 or request a free estimate with the form on the page. Our offices in Tamarac and Plantation take your request, and we match you with a vetted pro near you and book the visit.

We match homeowners across Coral Springs, including Eagle Trace, Heron Bay, Ramblewood, Turtle Run, Maplewood, Coral Creek, Wyndham Lakes, Kensington, Cypress Run, the Coral Springs Country Club area, Downtown Coral Springs / City Centre and the Mullins Park area.

How it works

  1. Step 1

    Tell us what you need

    Call or send the short form with your city and the job. Estimates are free.

  2. Step 2

    We match you with a vetted pro near you

    We pick a vetted pro from our network who works in your part of Florida and book the visit.

  3. Step 3

    Your pro gives a free estimate and does the work

    Your MB pro looks at the job and gives you a free estimate. You decide whether to go ahead — and we stay your point of contact.

Chimneys in Coral Springs: common questions

Do I need a licensed chimney sweep in Coral Springs?
Florida does not license chimney sweeps at the state level, so cleaning and inspection are generally unlicensed work. Ask about voluntary CSIA certification. Rebuilds and gas venting work do require a licensed contractor, which you can verify on the DBPR website.
Why would a Coral Springs home have chimney problems if chimneys are rare here?
Wood-burning fireplaces are rare in Coral Springs, so a chimney can sit unchecked for years. In the wet season, a cracked crown or loose flashing can let in rain, and an uncapped flue can attract nesting animals.
Does a chimney cap or crown repair here need special approval?
Coral Springs is in Broward County's High-Velocity Hurricane Zone, so caps, crowns and flashing must resist high wind uplift, and exterior products generally need a Miami-Dade NOA. If you are in an HOA, you may also need architectural approval. Your pro can help you check both.
Is it safe to light the fireplace if I think the chimney is damaged?
No. Stop using it if you see heavy creosote, smoke coming back into the room, or storm damage to the stack. Have your MB pro inspect it first.
Do homes built around 1986 need extra chimney attention?
The Census puts the median build year here at 1986, so many chimneys are decades old. Stucco, flashing and crowns weather over that time in Coral Springs' humid climate, and an inspection shows whether anything needs repair.

Request a free chimneys estimate in Coral Springs

Tell us what's going on. We'll match you with a vetted pro near you.

  1. 1Tell us what you need.
  2. 2We match you with a vetted pro near you.
  3. 3Your pro gives a free estimate and does the work.

Prefer to talk?

(954) 707-6550

We only use your details to handle your request and share it with your MB pro. See our privacy policy and terms.

(954) 707-6550Free estimate